AC MACHINES-1 (66761) Theory

Describe speed control by changing applied voltage, changing applied frequency and

changing stator poles.

1. By changing the applied voltage:

From the torque equation of induction motor,
Rotor resistance R₂ is constant and if slip s is small then (sX₂)² is so small that it can be neglected. Therefore, T ∝ sE₂² where E₂ is rotor induced emf and E₂ ∝ V
Thus, T ∝ sV²,  which means, if supplied voltage is decreased, the developed torque decreases. Hence, for providing the same load torque, the slip increases with decrease in voltage, and consequently, the speed decreases. This method is the easiest and cheapest, still rarely used, because

1. large change in supply voltage is required for relatively small change in speed.
2. large change in supply voltage will result in a large change in flux density, hence, this will disturb the magnetic conditions of the motor.

2. By changing the applied frequency

Synchronous speed of the rotating magnetic field of an induction motor is given by,
where, f = frequency of the supply and P = number of stator poles.
Hence, the synchronous speed changes with change in supply frequency. Actual speed of an induction motor is given as N = Ns (1 - s). However, this method is not widely used. It may be used where, the induction motor is supplied by a dedicated generator (so that frequency can be easily varied by changing the speed of prime mover). Also, at lower frequency, the motor current may become too high due to decreased reactance. And if the frequency is increased beyond the rated value, the maximum torque developed falls while the speed rises.

3. Constant V/F control of induction motor

This is the most popular method for controlling the speed of an induction motor. As in above method, if the supply frequency is reduced keeping the rated supply voltage, the air gap flux will tend to saturate. This will cause excessive stator current and distortion of the stator flux wave. Therefore, the stator voltage should also be reduced in proportional to the frequency so as to maintain the air-gap flux constant. The magnitude of the stator flux is proportional to the ratio of the stator voltage and the frequency. Hence, if the ratio of voltage to frequency is kept constant, the flux remains constant. Also, by keeping V/F constant, the developed torque remains approximately constant. This method gives higher run-time efficiency. Therefore, majority of AC speed drives employ constant V/F method (or variable voltage, variable frequency method) for the speed control. Along with wide range of speed control, this method also offers 'soft start' capability.

4. Changing the number of stator poles

From the above equation of synchronous speed, it can be seen that synchronous speed (and hence, running speed) can be changed by changing the number of stator poles. This method is generally used for squirrel cage induction motors, as squirrel cage rotor adapts itself for any number of stator poles. Change in stator poles is achieved by two or more independent stator windings wound for different number of poles in same slots.
For example, a stator is wound with two 3phase windings, one for 4 poles and other for 6 poles.
for supply frequency of 50 Hz
i) synchronous speed when 4 pole winding is connected, Ns = 120*50/4 = 1500 RPM
ii) synchronous speed when 6 pole winding is connected, Ns = 120*50/6 = 1000 RPM